Builder’s Choice Collection

[Wood Grain | SPC | 4.5MM]

LIMITED WARRANTY

Finish: Limited Lifetime
Structural: 10 year Commercial

SERIES INFORMATION:

#1420 WG-RIG-#1430 WG-RIG

Thickness4.5MM
Width7 1/8”
Length48"
Wear Layer12MIL
SF/BOX28.84
BX/PLT50
SF/PLT1442
BX/WGT44
SF/WGT1.53 lbs
Waste %4-6%

INSTALLATION:

  • Nail
  • Nail/Glue Assist
  • Glue Only
  • Float
  • Click
  • Below Grade
  • Radiant Heat

ADDITIONAL INFORMATION:

Core ConstructionTuffcore SPC (Polyvinyl Chloride)
Core TypeSPC (Virgin) 2000+ PSI
Joint System Valinge 2g Click
TextureWire Brushed
Edge ProfilePressed Edge .7mm
Finish Type2 Coats of UV cured urethane infused with ceramic.
Gloss Levels5 - 7%
MaintenanceZEP Neutral Floor Cleaner
Repair FinishDr. Schutz Scratch Fix - Vinyl Design Floor Repair
Expansion Requirements1/4” expansion gap for the first 20 Lineal feet (length or width). Add additional 1/16” for every 5’ of install (length or width) upto 1/2”. T-molds are required for rooms exceeding 50 lineal feet in length and width and 40 lineal feet for installations over in floor radiant heat.
UsesResidential - Commercial

COMPLIANCE:

This series has been tested and contains the following certifications:

COMMON QUESTIONS:

SUBSTRATE REQUIREMENTS
Structurally sound, well bounded, flat to within 3/16” in 10’ radius or 1/8” in 6’ radius, vertical deflection cannot exceed 1/4” in 10’ Radius, or more than 1/16” between the floor joist.

APPROVED SUBSTRATES
Underlayment APA grade CDX plywood/OSB, 3000 PSI concrete or 2500 PSI gypcrete. Underlayment grade MDF. See installation guide for additional approved substrates.

WOOD SUBFLOOR (EMC) MOISTURE CONTENT REQUIREMENTS
Should not exceed 12% MC (moisture content).

CONCRETE AND GYPCRETE MOISTURE EMISSIONS, RH, AND PH REQUIREMENTS
Properly install a minimum of 6mil plastic over the entire sub-strate. Overlap all seams 12” and tape all seams with moisture proof tape.

JOBSITE CONDITION RANGES
RH between 30-60% and room temperature between 60 to 80°F. Post installation temperature range must be within 10 to 142°F.

ACCLIMATION TIMEFRAME
No acclimation is required if the product was stored and/or transported in 60 to 80°F for at least 24 hours prior to installation. Otherwise, it must acclimate for a minimum of 24 hours. Please see installation guide for radiant heat application.

CAN WE INSTALL A CUSHION UNDERNEATH THE FLOOR?
This product has an attached 1mm thick high density EVA cushion. An additional cushion is not compatible.

RUG COMPATIBILITY
Must be breathable, non abrasive, natural fiber rugs. Please see RugPadUSA.com. For example; Anchor Grip, Nature’s Grip, RugPro, or Super Lock Natural.

BUILDER’S CHOICE COLLECTION SPC WATERPROOF FLOORING: